Hunting in Synchronous Motor

 We come across the term HUNTING when we study about three phase synchronous motor operations. The word hunting is used because after sudden application of load the rotor has to search or hunt for its new equilibrium position. That phenomena is referred as hunting in synchronous motor. Now let us know what is the condition of equilibrium insynchronous motor.

A steady state operation of synchronous motor is a condition of equilibrium in which the electromagnetic torque is equal and opposite to load torque. In steady state , rotor runs at synchronous speed thereby maintaining constant value of torque angle (δ).

WHAT IS HUNTING?

Unloaded synchronous machine has zero degree load angle. On increasing the shaft load gradually load angle will increase. Let us consider that load P1 is applied suddenly to unloaded machine shaft so machine will slow down momentarily. Also load angle (δ) increases from zero degree and becomes δ1. During the first swing electrical power developed is equal to mechanical load P1. Equilibrium is not established so rotor swings further . Load angle exceeds δ1 and becomes δ2 . Now electrical power generated is greater than the previous one. Rotor attains synchronous speed. But it does not stay in synchronous speed and it will continue to increase beyond synchronous speed. As a result of rotor acceleration above synchronous speed the load angle decreases. So once again no equilibrium is attained. Thus rotor swings or oscillates about new equilibrium position. This phenomenon is known as hunting or phase swinging.

CAUSES OF HUNTING IN SYNCHRONOUS MOTOR

• Sudden change in load
• Sudden change in field current
• A load containing harmonic torque
• Fault in supply system

EFFECTS OF HUNTING IN SYNCHRONOUS MOTOR

• It may lead to loss of synchronism.
• Produces mechanical stresses
• Increases machine losses and cause temperature rise
• Cause greater surges in current and power flow

REDUCTION OF HUNTING IN SYNCHRONOUS MOTOR

Two techniques should be used to reduce hunting. These are –
• Use of damper windings : It consists of low resistance copper /alumunium brush embedded in slots of pole faces in salient pole machine. Damper winding damps out hunting by producing torque opposite to slip of rotor. The magnitude of damping torque is proportional to the slip speed.
• Use of flywheels : The prime mover is provided with a large and heavy flywheel. This increases the inertia of prime mover and helps in maintaining the rotor speed constant.
• Designing synchronous machine with suitable synchronizing power coefficients.